Data Transmission Delay Time Setting; Setting The Display Units Of The Aprs Data - Yaesu FTM-400DR Instruction Manual

Data transmission delay time setting

The following preamble (data transmission delay time) can be set when sending APRS
data.
Start of transmission
1
Press for one second or longer
The set-up menu will be displayed.
2
Select and touch [APRS]
3
Select and touch [11 APRS TX DELAY]
The screen for setting the data transmission delay
time will be displayed.
4
Touch the desired delay time
The delay time can be selected from the following 9
steps.
"100", "150", "200", "250", "300", "400", "500", "750",
"1000"
Tip Factory default value: 250
5
Press for one second or longer
The data transmission delay time is set and the
display returns to the previous screen.

Setting the display units of the APRS data

This sets the units for the latitude / longitude (POSITION), distance (DISTANCE), speed
(SPEED), altitude (ALTITUDE), atmospheric pressure (BARO), temperature (TEMP),
rainfall (RAIN) and wind (WIND).
1
Press for one second or longer
The set-up menu will be displayed.
2
Select and touch [APRS]
3
Select and touch [12 APRS UNITS]
The unit setting screen for the APRS display will be
displayed.
APRS beacon transmission content
Preamble
(data transmission delay time)
(factory shipping value: 250ms)
Hours
77
Using the APRS Set-up Menu
End of transmission
APRS data