VOX Operation
The VOX system provides automatic transmit/receive switching based on voice input to
the microphone or Bluetooth Headset. With the VOX system enabled, you do not need
to press the PTT switch in order to transmit, and it is not necessary to use a VOX head-
set in order to utilize VOX operation.
Setting VOX function
1. Press and hold the [F(SETUP)] key.
2. Rotate the DIAL knob (Band A) to select "TX/RX", then press the DIAL knob (Band A).
3. Rotate the DIAL knob (Band A) to select "3 AUDIO", then press the DIAL knob (Band
A).
4. Rotate the DIAL knob (Band A) to select "3 VOX", then press the DIAL knob (Band A).
5. Press the DIAL knob (Band A), and then rotate the DIAL knob (Band A) to select
"LOW" or "HIGH".
OFF:
VOX function OFF
LOW: VOX function ON (VOX Gain Levl "LOW")
HIGH: VOX function ON (VOX Gain Levl "HIGH")
6. Press the DIAL knob (Band A).
7. Press the [DISP] key to return to the normal operation.
● Disable the VOX function
To cancel VOX and return to PTT operation, just repeat the above procedures, se-
lecting "OFF" in step 5 above.
Set the VOX (automatic voice transmission) delay time
During transmission with VOX (automatic voice transmission) function, set the time to
stop speaking and return to reception.
1. Press and hold the [F(SETUP)] key.
2. Rotate the DIAL knob (Band A) to select "TX/RX", then press the DIAL knob (Band A).
3. Rotate the DIAL knob (Band A) to select "3 AUDIO", then press the DIAL knob (Band
A).
4. Rotate the DIAL knob (Band A) to select "3 VOX", then press the DIAL knob (Band A).
5. Rotate the DIAL knob (Band A) to select "DELAY", then press the DIAL knob (Band
A).
6. Rotate the DIAL knob (Band A) to select the delay time (the transmit-receive delay
after the cessation of speech).
0.5sec / 1.0sec / 1.5sec / 2.0sec / 2.5sec / 3.0sec
7. Press the PTT switch or the [DISP] key to return to the normal operation.
Application for FCC/IC
FCC ID: K6620715X40
IC: 511B-20715X40
23