Table of Contents
Advertisement
Nailing Brackets – Flush Install
The fireplace has nailing brackets on both sides. Secure the fireplace to the framing.
NOTE: Make sure the fireplace is square and plumb when placed in the framing. Measured corner-to-corner
the fireplace should be square. Use shims to insure the fireplace is square.
NOTE: if you can not use the
front nailing brackets, an
additional bracket is supplied on
the side that allows the fireplace
to be secured to the floor (bend
tab down and secure).
Bend the side nailing brackets as shown below.
a
Rotate the bracket on the
rivet 180 degrees.
© Travis Industries
Installation
(for qualified installers only)
Bend the top nailing bracket
as shown until it is flush with
the front of the fireplace.
c
b
Secure the fireplace to
the framing using the
nailing brackets and
vertical drywall support.
Bend the vertical drywall support forward.
The mounting hole is now vertical and may
be secured to the framing from below.
4150624
15
100-01425
Advertisement
Table of Contents
