Compatibility
616 GSR, GSR2
430 GSR2
Packing List
STAINLESS STEEL WARNINGS
HANDLING THE FIREBACKS: The stainless steel firebacks are shipped in vinyl to prevent marring the
surface of the stainless steel. Remove the vinyl prior to installation. Wear clean gloves when
installing the firebacks to prevent fingerprints on the surface (or use a rag or paper towel to handle
the firebacks).
COLORATION AND CLEANING: These stainless steel firebacks will obtain a slight "patina" (brown
tint) after use. Do not clean the firebacks. This patina becomes consistent. Any cleaning may lead to
unequal coloring. If soot forms on the fireback, we recommend brushing it off with a soft cloth or brush.
CLEANING ENAMEL FIREBACKS
We recommend cleaning the enamel surface with glass cleaner and a soft cloth.
CURING BLACK PAINTED FIREBACKS
The black painted firebacks will fully cure under heat. Run the appliance on low for several hours to
cure the paint. The firebacks may be touched-up using Forrest "Metallic Black" paint.
Page 1 of 3
616 / 430 Fireback Installation Instructions
SKU's: 96100924, 926, 927, 928, 929
SKU's: 96100917, 918, 919, 920, 921
17601680 — 7/14/15
Rear, Left and Right Firebacks
NOTE FOR CERAMIC FIREBACKS:
The rear fireback is rectangular and must be
placed right-side-up. Lay the firebacks on a flat
surface prior to installing to verify the grout lines
are aligned.
© Travis Industries, Inc.