Fuji Xerox APEOSPORT-II C7500 User Manual page 51

1
Remove any paper clips and
staples before loading the
document.
2
Adjust the movable document
guides to match the size of the
document loaded.
Note
3
Place the document (the front side
of 2-sided document) face up in the
center of the document feeder.
Note
Document Glass
The document glass supports a single sheet, a book, or other similar documents up to
297 x 432 mm (A3, 11 x 17 inches).
Important • After using the document glass, close the document cover.
The document glass automatically detects standard size documents. For non-standard
size documents, input the size in the [Original Size] screen.
For information on entering document sizes, refer to "Original Size (Specifying the Scan Size for the
Document)" (P.76).
Note
CAUTION
Do not apply excessive force to hold thick document on the platen glass. It may break
the glass and cause injuries.
1
Open the document cover.
Important • Ensure that a screen is
• When loading a large
document such as A3, open
the document stopper
rightward.
• The indicator lights up when
the document is loaded
correctly.
• The standard document sizes that can be detected automatically depend on the [Paper Size
Settings] in the System Administration mode. For information on the paper size settings,
refer to "6 System Settings" > "Common Settings" > "Other Settings" > "Paper Size Settings"
in the Administrator Guide.
displayed on the control
panel, and then load a
document. If a document is
loaded before a screen is
displayed, the machine may
not properly detect the
document size.
Copying Procedure
Indicator
3
49