Mounting The Tail Wheel - Seagull Models EXTRA 260 Instruction Manual

EXTRA 260. Instruction Manual.
! 1) You have to trim each axles and using a
tool cutting and cut-off wheel.
Aluminium strap.
Caution when cutting the axles wear
protective goggles.
3x10mm.
1 1
2
2
1
1
(1+2) Plastic clip.
1
3x25mm.
2
! 2) Set the tail wheel assembly in place.
The pivot point of the tail wheel wire should
be even with the rudder hinge line and the tail
wheel bracket should be on the plywood
plate.
! 3) Using a pen, mark the locations of the

MOUNTING THE TAIL WHEEL.

four mounting screws. Remove the tail wheel
bracket and tiller and drill 1mm pilot holes at
the locations marked.
33mm.
20