Table of Contents
Advertisement
MAINTENANCE
1.TROUBLESHOOTING
Problem
Fixtures does not
work
Reset normally, but
console abnormally
or no response
2. CLEANING
Though increasing reliability by designing well and we never stop to improve quality to
lengthen lamp's lifespan. It is still indispensable to maintain it well by certain time in order
to ensure best performance
First , clean fan and vent.
Favorable heat-dissipation and ventilation is vital to lamp's normal work. So clean the fan
and vent during a certain time to guarantee smooth of wind path. Otherwise dust will
barrier vent, which will affect the performance because of over heat after working for some
time.
Second, lens cleaning and maintenance
LEDMH100 MOVING HEAD
Probable cause(s)
No power source
Fuse burnt
False or incomplete data
connection
False address setting
Problem
of
signal
connector
of
some
fixtures
Signal output does not
match with the pin (pins2
and pins3 has a wrong
sequence)
Suggested remedy
Check if power source is on or cord works
well.
Cut off power source and change the
same type fuse. If fuse was burnt on end,
it may be the problem of connection; Find
qualified professors to repair.
Check, repair or change the data line.
Ensure connection is well and the first
lamp's single input is connected with the
controller output.
Check DMX address.
Pull out the signal output and input of one
fixture. Then connect both directly. If it
works well, this fixture is proved to be the
failed one. Handle the rest fixtures alike to
check which fixture has problems. If any
problem, please connect the technician.
Toggle
the
controller to reverse the polarity.
11
PHASE
button
on
the
Advertisement
Table of Contents
