Cable Remote Control (X-4); Part 5. Maintenance - involight ALPINA600 User Manual

4.2 Cable remote control (X-4):

Plug the cable remote control into the 5-pin socket on the back of the unit (see section 4.1 housing parts). Switch
on the machine with the power switch on the back (see section 4.1 Housing parts). The red LED (3.) lights up.
Activate the remote control with the switch (4.). The green LED (2.) lights up. The remote control is now active. Use
the knob (1) to adjust the desired output quantity (from left to right (1% - 100%)).
1.
2.
3.
4.

Part 5. Maintenance:

Regularly check the technical safety of the snowmachine. To damage the leads and the housing. There are no
parts to be serviced in the device interior, except the fuse. Maintenance and service are reserved for authorized
dealers only!
Cleaning.
The device should be regularly cleaned of impurities such as dust, etc. For external cleaning, use a dry, soft cloth,
never use chemicals or water that could enter the unit. Clean the ventilation openings with a soft brush, cotton
swab, a vacuum cleaner or compressed air.
fuse replacement
.
IMPORTANT: Replace the fuse only with a fuse of the same type and with the same values (printed on the device).
If the fuse is triggered repeatedly, please contact an authorized service center.
Method:
1: Unplug the power cord from the wall outlet.
2: Open the fuse holder on the back of the unit with a suitable screwdriver.
3: Remove the defective fuse from the fuse holder.
4: Insert the new fuse into the fuse holder.
5: Replace the fuse holder in the housing.
Maintenance and service work is reserved for the authorized personnel only!
13