The shield connection is pin 1, while pin 2 is Data Negative (S-) and pin 3 is Data positive
(S+).
2. LAMP BODY INSTALLATION
Notes: do not install it nearby the curtain or flammable materials.
Only for indoor use.
OPERATION
1.SET DIPSWITCHES
■Each fixture occupies 11 DMX channels.
■DMX 512 signal can control multi-fixtures together, however you must set DMX address of
each lamp first. Different DMX address will lead to different movements.
■You can set DMX address from 1~501 on the multi-function display panel.
■Switch on power supply and after finishing resetting, the panel will show 001,that is to say
DMX address is 1 and the first lamp has been controlled by 1~11channels.In turn the
second fixture has been controlled by 12~22 channels. (When panel shows 001,press
UP button until it shows 012.Then just press ENTER button). In the same way, the third
fixture has been controlled by 23~33 channels and the panel shows023.
■Through this method, you can control multi-fixtures to perform different movements.
LEDMH100 MOVING HEAD
5