Table of Contents
Advertisement
[RGB]
[DIGITAL LINK]
[INPUT1] - [INPUT10]
*1 When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100C) is connected to the projector, its input name is
automatically reflected from [INPUT1] to [INPUT10]. When an item that does not reflect the input name is selected, it will be disabled.
Note
f When the [DISPLAY OPTION] menu → [BACKUP INPUT SETTING] → [BACKUP INPUT MODE] is set to a combination of the DVI-D input
and HDMI input, and the power is turned off with the input set to HDMI during previous use, the projection will start with the DVI-D input
even if [STARTUP INPUT SELECT] is set to [LAST USED].
[DATE AND TIME]
Set the time zone, date, and time of the built-in clock of the projector.
Setting the time zone
1)
Press as to select [DATE AND TIME].
2)
Press the <执行> button.
f The [DATE AND TIME] screen is displayed.
3)
Press as to select [TIME ZONE].
4)
Press qw to switch [TIME ZONE].
Note
f The [TIME ZONE] setting is reset to the factory default setting when the projector is initialized by one of the following methods. However, the
date and time based on the local date and time setting (Coordinated Universal Time, UTC, Universal Time, Coordinated) will be maintained
without being initialized.
g When initialized by selecting the [PROJECTOR SETUP] menu → [INITIALIZE] → [FACTORY RESET]
g When initialized by setting the [PROJECTOR SETUP] menu → [INITIALIZE] → [USER SETTINGS] → [OTHER USER SETTING] to
[INITIALIZE]
Setting the date and time manually
1)
Press as to select [DATE AND TIME].
2)
Press the <执行> button.
f The [DATE AND TIME] screen is displayed.
3)
Press as to select [ADJUST CLOCK].
4)
Press the <执行> button.
f The [ADJUST CLOCK] screen is displayed.
5)
Press as to select an item, and press qw to set the local date and time.
6)
Press as to select [APPLY], and press the <执行> button.
f The setting of the date and time will be completed.
Note
f The replacement of the battery inside the projector is required when the time goes out of alignment right after correcting the time. Consult
your dealer.
Setting the date and time automatically
To set the date and time automatically, the projector must be connected to the network.
1)
Press as to select [DATE AND TIME].
2)
Press the <执行> button.
f The [DATE AND TIME] screen is displayed.
3)
Press as to select [ADJUST CLOCK].
132 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Sets the input to RGB.
Sets the input to DIGITAL LINK.
Sets the input to DIGITAL LINK, and switches the input of the DIGITAL LINK output supported device
*1
to the specified input.
Advertisement
Table of Contents
