Settings Required To Use Scan To Folder Function - Ricoh C3030 Operating Instructions Manual

Connecting the Machine
Note
❒ In [Effective Protocol], check that the protocol you want to use is set to [Active].
❒ [LAN Type] is displayed when the wireless LAN interface board is installed. If
both ethernet and wireless LAN (IEEE 802.11b) are connected, the selected in-
1
terface takes precedence.
❒ When [POP before SMTP] is set to [On], also make setting for [Reception Protocol]
and [POP3 / IMAP4 Settings].
❒ When setting [POP before SMTP] to [On], check[POP3] port number in [E-mail
Communication Port].
Reference
p.58 "Interface Settings"
p.68 "File Transfer"

Settings Required to Use Scan to Folder Function

This section lists the settings required for sending file.
Ethernet
This section lists the settings required for sending file with ethernet cable.
For details about how to specify the settings, see "Interface Settings" and "File
Transfer".
Menu
Interface Settings/Network Machine IPv4 Address
Interface Settings/Network IPv4 Gateway Address
Interface Settings/Network DNS Configuration
Interface Settings/Network DDNS Configuration
Interface Settings/Network Domain Name
Interface Settings/Network WINS Configuration
Interface Settings/Network Effective Protocol
Interface Settings/Network Ethernet Speed
Interface Settings/Network LAN Type
Interface Settings/Network Permit SNMPv3 Communication
Interface Settings/Network Permit SSL/TLS Communication
Interface Settings/Network Host Name
File Transfer
File Transfer
24
User Tool
Scanner Resend Interval Time
Number of Scanner Resends
Setting Requirements
Neccessary
Neccessary
As required
As required
As required
As required
Neccessary
As required
Neccessary
As required
As required
As required
As required
As required