12Vdc Mute Trigger In/Trigger Out - Russound CAA66 Installation Manual

12VDC Mute Trigger In
When 12VDC is applied to the Mute In, the sys-
tem will fully mute all zones in the system. The
connections for the trigger are made using a two-
conductor cable with 1/8" male mini-plug jacks.
The tip is positive (+) and sleeve is negative (-).
This allows for the connection of an external pag-
ing or muting device. Note: The CAA66 will not
accept a paging audio input; however, if used
with an independent paging system with 12V trig-
ger out, that can be used to trigger the mute.
12VDC Power
Supply
12VDC Mute Trigger In/System Trigger Out
12VDC System Trigger Out
Trigger Out 12VDC output is used for triggering
an external amplifier or other component. The
connections for the output are made using a
two-conductor cable with 1/8" male mini-plug
jacks at each end. The tip is positive (+) and
sleeve is negative (-). The System Trigger Out
supplies 12VDC when the first keypad is turned
on. The 12 VDC is removed 5 minutes after the
last keypad is turned off.
Doorbell Interface
INSTALLER
MAKING CONNECTIONS
R235LS (two-channel amplifier)
CAA66
25