A-Bus Ready Sub-Zone Connection; 12Vdc Trigger In/Out; 50Ma Trigger Out - Russound CAV6.6-S2 System Instruction Manual

INSTALLER
MAKING CONNECTIONS

A-BUS Ready Sub-Zone Connection

A-BUS products can easily expand the CAV6.6
audio system by adding A-BUS Ready Sub-zones
to the first four CAV6.6 zones. The A-BUS Ready
Sub-zones are located on the back of the
CAV6.6 at the bottom left corner. The A-BUS
Ready Sub-zones are powered by a 24VDC
power supply such as the A-PS.
Use an RJ-45 CAT-5 T568A configuration patch
cable to connect the A-BUS Ready Sub-zone
34
port to an RJ-45 wall plate (optional) for a clean
installation. Using the same T568A RJ-45 wiring
configuration, attach CAT-5 from the RJ-45 wall
plate to an A-BUS hub or amplified control mod-
ule such as the A-KP2 keypad.
If using an A-BUS hub with the A-BUS Ready Sub-
zone, the hub should be located near the
CAV6.6 and wired directly instead of first going
through the wall plate.

12VDC Trigger In/Out

12VDC Home Theater Trigger In
This 12VDC Trigger input is used to control
Power Management of the audio/video sources
possibly being shared with a home theater sys-
tem. When the source equipment is off and
12VDC is provided to the trigger, the sources will
be turned on until it is removed. When the last
zone on the CAV6.6 is turned off, 12VDC pres-
ence to the trigger input will prevent the sources
from being turned off. The connections for the
trigger are made using a two-conductor cable
with 1/8" male mini-plug. The tip is positive (+)
and the sleeve is negative (-).
INSTALLER
MAKING CONNECTIONS
12VDC 50mA Trigger Out
The 12VDC 50mA trigger out can be used to
engage any 12VDC trigger device or component
such as the Russound ACT-1 triggered outlet.
The connections for the trigger out are made
using a two-conductor cable with 1/8" male
mini-plug jacks at each end. The tip is positive
(+) and sleeve is negative (-).
35