Russound CAA66 Installation Manual page 80

Repeat procedures for Zones 2 through 6
The last few items listed below are repeated procedure to test zone 2 through 6.
1. Turn off the CAA66 by pressing the power button on the front panel.
2. Move the KP6 to the next Keypad Port.
Move the speaker to the same numbered port your keypad is connected to.
3. Turn on the CAA66 by pressing the power button on the front panel.
4. Repeat the process of testing each Zone by repeating the following sections:
***The Source and IR Selection Test,
the Treble, Bass, Balance, and Loudness Test,
and the Front Panel LED, Trigger Out, and Page Mute Test
The only difference is
When the KP6 is in Keypad Port 1 the Speakers are in Port 1
When the KP6 is in Keypad Port 2 the Speakers are in Port 2
When the KP6 is in Keypad Port 3 the Speakers are in Port 3
When the KP6 is in Keypad Port 4 the Speakers are in Port 4
When the KP6 is in Keypad Port 5 the Speakers are in Port 5
When the KP6 is in Keypad Port 6 the Speakers are in Port 6
5. You must test each keypad port before proceeding to the
next page of the test procedure.
CAA66 Test Procedure
Revised July 22, 2005
27 of 44