Russound CAA66 Installation Manual page 96

Factory Init Test
1. Connect 110VAC to the rear of the CAA66.
2. Press the power button on the Front Panel of the CAA66.
3. Press the on/off button on the KP6.
4. The KP6 and CAA66 will turn on and illuminate to a Source.
5. Press and Hold the Setup button on the Programming Center.
You are in the Program Mode.
6. The Green Ctrl ID LED will illuminate.
7. Momentarily press the Setup button twice.
8. The Orange Fact Init LED will illuminate.
9. Press the Mute then the OK button on the SRC1.
10. The Fact Init LED will blink twice then go dark showing Factory Init is in progress.
11. The Fact Init process could take up to 3 minutes to complete.
12. When the Green, Yellow, and Orange LED illuminate Cycle the Power.
13. Factory Init has completed.
14. Testing is complete of the CAA66.
CAA66 Test Procedure
Revised July 22, 2005
43 of 44