Alternate Osd Key; Figure 37- Alternate Osd Screen - Network Technologies CAT5 Primux Installation And Operation Manual

Alternate OSD Key

This function enables the administrator to assign a key in addition to the <`> (accent key) to use with <Ctrl> to enter into OSD
Command Mode. The default factory setting for this option is <0> (disabling the option).
To assign an Alternate OSD key press <K> from the Administration Menu. (From Command Mode type <A>-<K>.)
A window will open displaying the current "Cur" value, the range of values (from 4 to 164), and a place for the new value to be
assigned. As the administrator changes the value, the corresponding keyboard key will appear next to it in parenthesis. Enter
the value "0" to disable the feature.
Function Keystroke
Press key to enter directly P <x>
x= any key on the
keyboard
Increment value by 1 Up arrow
Decrement value by 1 Down Arrow
Increment value by 10
Page Up
Decrement value by 10 Page Down
Insert minimum value Home
Insert maximum value End
Save new value S or Enter
Disable feature (input value 0) D
Esc X or Esc

Figure 37- Alternate OSD screen

After pressing <S> to save or <D> to disable, the new value will replace the "Cur. Value" as the current value. This function
effects all users of the segment..
FYI: The Alternate Command Hot Key does not replace the <`> (accent) key, it just works as an additional way to enter
into Command Mode. After setting it, the user can enter into Command Mode either with <Ctrl> + <`> or with <Ctrl> +
<Alternative Command Hot Key> combination. To disable it, the administrator should set the new value at 0 or press
<D>.
31