Installing The Receiver - Seagull Models T-6A Texan II Assembly Manual

165mm.
8mm.
M2 x 6mm.

INSTALLING THE RECEIVER.

1) Plug the servo leads and the switch
lead into the receiver. Plug the battery pack
lead into the switch also.
2) Wrap the receiver and battery pack in
the protective foam rubber to protect them
from vibration.
3) Route the antenna in the antenna tube
inside the fuselage and secure it to the bot-
tom of fuselage using a plastic tape. See pic-
ture below.
www.seagullmodels.com
Tie Wrap.
8mm.
Bolt the wing to fuselage.
When balanced correctly, the airplane should
sit level or slightly nose down when you lift it
up with your fingers.
Receiver.
ATTACHMENT WING - FUSELAGE.
Wing bolt.
D.
C/A glue.
D.
23