Messaging Settings - ASCOM d62 Configuration Manual

Configuration Manual
Ascom d62 DECT Handset

5.26 Messaging Settings

Note: This feature is applicable for d62 Messenger and d62 Protector only.
It is possible to configure how incomming messages shall be indicated and displayed in
handset. The parameters can be found at:
Settings > Sound and Alerts
• Vibrate alert
Determines if the handset shall vibrate when receiving incoming calls and messages.
• Message alert
Determines the message sound for incoming messages. It is possible to select a
predefined melody (Message 1 - Message 7) or a beep code that represents a certain
sound. For more information on how to configure sounds with beep codes, see
Configure Message Alerts with Beep Codes
• Message volume
Determines the message volume for incoming messages. By default, the message
volume follows the ringer volume, but another message volume can be set with this
parameter.
• Vibrator for message during call
Determines if the handset shall vibrate when receiving messages during an ongoing call.
Settings > Messaging
• Text size
Size of the message text when viewing and writing messages.
• Time to Read (TTR)
Determines if the user needs to close a message manually, or if the message
automatically shall be closed when TTR expires. Regardsless how a message is closed, it
is removed from the message queue and stored in the Messaging Inbox. TTR starts when
a message is displayed and keep running also when the message is placed in the
messaging queue. If a user presses any key when a message is displayed, the TTR is
reset. See also
• Time to Prioritize (TTP)
Determines how long messages shall keep their priority status. The TTP starts when a
message is displayed. If a user presses any when a message is displayed, the TTP is reset.
If receiving a message with higher priority than the displayed message, the message
with lower priority is placed in queue and its TTP is paused. When the TTP elapsed for a
message, it is put last in the queue. See also
36.
• Message List representation
Can be set to text or number.
• Repeat Message Indication
This parameter enables/disables message indications. It sets whether a message
indication shall be repeated until confirmed by the user or not. The current repetition
rate is 7 seconds. If the message itself contains a repetition, it overrides this setting.
• IM (Interactive Messaging) Option Mode
This parameter is used for older applications and sets that three soft keys shall be placed
automatically, i.e. on soft keys or in an option menu (list).
• Call priority
Determines if call information shall be presented on the display during incoming call
when viewing a message. 0 = Call indication will override all messages (default).
1-9 = Comparison with message priority, the call priority must be higher in order to show
call information. 10 = Call indication on the display will always be hidden.
25 November 2011 / Ver. E
5.26.2 Example of TTR/TTP settings
on page 35.
on page 36.§
5.26.2 Example of TTR/TTP settings
TD 92639EN
5.26.1
on page
34