Replacement Procedure Choice Guide; Replacement Of Handset With The Ims3 - ASCOM d62 Configuration Manual

Configuration Manual
Ascom d62 DECT Handset
2 Select "Factory Reset".
3 A Reset portable? dialogue appears, press "Yes". The handset will be restarted.
4.6

Replacement procedure choice guide

Depending on situation, two different replacement procedures can be chosen; replacement
via PDM/IMS3 and Easy Replacement. Use the following list as a guide to choose which
procedure to use.
• If a handset needs to be replaced due to for example a broken display, see User Manual,
Ascom d62 DECT Handset, TD 92477GB.
• If the electrical connection is damaged, it might not be possible to follow the Easy
Replacement procedure. Depending on fault, it might work to do a replacement via PDM/
IMS3, see
Replacement with the PDM Windows Version
• If two handsets and their settings shall be switched between two users, follow

Replacement of Handset with the IMS3

PDM Windows Version
4.7 Replacement of Handset with the IMS3
Both the old handset and the new handset must be of the same device type (d62 or d41).
The same extension number is assigned to the new handset.
Make sure that the old handset is saved in the IMS3. Start the Device Manager in the IMS3
and navigate to the "Numbers" tab. There shall be a tick in the "Saved" column for the old
handset.
If the handset is not saved, insert it into a desktop charger or rack charger connected to
IMS3 and perform a save, see Installation and Operation Manual, IMS3, TD 92762EN.
If it would be impossible to save the old handset settings, stop this replacement procedure.
Instead unsubscribe the old handset from the PBX, register the new handset and follow the
instructions for installing a handset, see
When the handset is saved, unsubscribe the old handset from the PBX.
The following steps are described in two different scenarios, check which one suits the best
before proceeding.
4.7.1 Data included in a replacement transfer
The following data is replaced during a replacement with IMS3:
• User parameters (including User ID)
• Contacts (entered by the user)
Note that the following data is not replaced:
• DECT registration
• Call list
• Messages
• Bluetooth pairing list
• Company phonebook
• Downloaded Language
• Licenses
25 November 2011 / Ver. E
4.7 Replacement of Handset with the IMS3
on page 15.
1
on page 14 or
on page 15.
on page 14 or 4.8 Handset Replacement with the
3.2 Installation of a new handset
TD 92639EN
4.8 Handset
4.7
on page 7.
14