Cisco 7200 VXR router User Manual page 45

Table 1-9 I/O Controller LEDs (Continued)
LED Function
2
FE link Indicates that the Fast Ethernet port on the I/O controller has
established a valid link with the network. This LED remains off
during normal operation of the router, unless there is an incoming
carrier signal.
MII EN Indicates that the Fast Ethernet port's MII receptacle is initialized
and enabled by the system, and configured for operation. This LED
comes on after the I/O controller has been enabled and the MII
receptacle has been configured as the media type for the
Fast Ethernet port (the RJ-45 receptacle is the default media type for
the Fast Ethernet port). This LED remains on during normal
operation of the router.
RJ45 EN Indicates that the Fast Ethernet port's RJ-45 receptacle (the default
media type for the Fast Ethernet port) is initialized and enabled by
the system. This LED comes on after the I/O controller has been
enabled and remains on during normal operation of the router.
RJ45 LINK Indicates that the Fast Ethernet port's RJ-45 receptacle has
established a valid link with the network. This LED remains off
during normal operation of the router, unless there is an incoming
carrier signal.
Slot 0 Slot 1 Goes on to indicate which PC Card slot is in use when either slot is
being accessed by the system. These LEDs remain off during normal
operation of the router.
1 This LED is found on the I/O controller with a single MII receptacle only.
2 This LED is found on the I/O controller with a single MII receptacle only.
The I/O controller without the Fast Ethernet port and the I/O controller equipped
Note
with a single MII receptacle do not have the MII enabled, RJ-45 enabled, and RJ-45 Link
LEDs.
Input/Output Controller
Cisco 7200 VXR Product Overview 1-35