Cisco 7200 VXR router User Manual page 146

Performing Other Configuration Tasks
Checking the Running Configuration Settings
You can check your settings and review any changes to your configuration using various
software commands.
To check the value of the settings you have entered, enter the show running-config
command at the
Router# show running-config
.
.
.
To review changes you make to the configuration, use the EXEC mode
show startup-config command to display the information stored in NVRAM.
Performing Other Configuration Tasks
To make advanced configuration changes after you establish the basic startup configuration
for your router, refer to the modular configuration and modular command reference
publications in the Cisco IOS software configuration documentation set that corresponds to
the software release installed on your Cisco hardware. These publications contain
additional information on using the configure command.
The configuration publications also provide information about the following tasks:
•
Understanding and working with the user interface on your router
•
Booting and rebooting the router
•
Setting the configuration register
•
Loading configuration files or system images using remote copy (rcp) or Trivial File
Transfer Protocol (TFTP)
•
Reloading the operating system
4-18 Cisco 7200 VXR Installation and Configuration Guide
prompt:
Router#