Cisco 7200 VXR router User Manual page 142

Configuring a Cisco 7200 VXR Router
The following sample display includes a continuous listing of all interface configuration
parameters selected for ATM, Fast Ethernet, and serial interfaces.
Configuring interface parameters:
Configuring interface ATM1/0:
Is this interface in use? [yes]:
Configure IP on this interface? [yes]:
Configure IPX on this interface? [yes]:
Configure AppleTalk on this interface? [no]: yes
Configuring interface FastEthernet2/0:
Is this interface in use? [yes]:
Use the 100 Base-TX (RJ-45) connector? [yes]:
Operate in full-duplex mode? [no]:
Configure IP on this interface? [yes]:
Configure IPX on this interface? [yes]:
Configure AppleTalk on this interface? [no]: yes
Configuring interface Serial3/0:
Is this interface in use? [no]: yes
Configure IP on this interface? [no]: yes
Configure IP unnumbered on this interface? [no]:
Configure IPX on this interface? [no]: yes
Configure AppleTalk on this interface? [no]: yes
4-14 Cisco 7200 VXR Installation and Configuration Guide
IP address for this interface: 1.1.1.10
Number of bits in subnet field [0]: 0
Class C network is 1.1.1.0, 0 subnet bits; mask is /24
IPX network number [2]:
Extended AppleTalk network? [no]: yes
AppleTalk starting cable range [0]:
IP address for this interface: 1.1.1.20
Number of bits in subnet field [0]:
Class C network is 1.1.1.0, 0 subnet bits; mask is /24
IPX network number [2]:
Extended AppleTalk network? [no]: yes
AppleTalk starting cable range [0]:
IP address for this interface: 1.1.1.20
Number of bits in subnet field [0]:
Class A network is 1.0.0.0, 0 subnet bits; mask is 255.0.0.0
IPX network number [2]:
Extended AppleTalk network? [no]:
AppleTalk network number [1]: