Cleaning And Maintenance - Zanussi ZTE285 User Manual

audible confirmation of:
• cycle end
• anti-crease phase start and end
• cycle interruption
• error
Tijd (Time)
after setting the Tijd (Time) programme. You can select
a programme duration from 20 mins to 2 hrs in 10-mi-
nute steps.
Startuitstel (Delay Start)
allows to delay the start of a drying programme from
minimum of 30 min. to maximum of 20 hours. Press
the Startuitstel (Delay Start) button repeatedly until the
desired delay start is shown on the display
Setting child lock
The child lock can be set to prevent a programme being
accidentally started or a programme in operation being
accidentally changed. The child lock function locks all
buttons and the programme selector. The child lock can
be activated or deactivated by holding down the Lage
temp. (Delicate) and Lang anti-kreuk (Long anticrease)
buttons simultaneously for 5 seconds.
– Before programme is started: Appliance cannot be used
– After programme is started: Programme in operation
cannot be changed
The icon appears in the display to indicate that the
child safety device is activated.
The child safety device is not deactivated once the pro-
gramme comes to an end.
If you want to set a new programme, you must first deacti-
vate the child safety device.
Starting the programme
Press the Start/Pauze (Start/Pause) button. The pro-
gramme starts.
The programme progress is shown by elapsing dry time
on the LCD.

Cleaning and maintenance

Cleaning fluff filters
The filters collect all the fluff which accumulates during
drying. To ensure that the dryer works perfectly, the fluff
24
Changing programme
To change a programme which is running, first cancel it
by turning the programme selector dial to
new programme and press the Start/Pauze (Start/Pause)
button.
The programme can no longer be changed directly
once the programme has started. If nevertheless
there is an attempt to change the programme on the pro-
gramme knob, the programme progress display and the
maintenance indicators flash. If an option button (exclud-
ing the Zoemer (Buzzer) button) is pressed,
pears on the display. The drying programme is not how-
ever affected by this (laundry protection).
Drying cycle complete / removing laundry
Once the drying cycle is complete, the display shows the
anti-crease icon and flashing as well as warning
lamps: Filter and Waterreservoir (Water Reservoir) . If the
Zoemer (Buzzer) button has been pressed, an acoustic
signal sounds intermittently for about one minute.
The drying cycles are automatically followed by an
anti-crease phase which lasts around 30 minutes.
The drum rotates at intervals during this phase. This
keeps the laundry loose and free of creases. The laundry
can be removed at any time during the anti-crease phase.
(The laundry should be taken out towards the end of the
anti-crease phase at the latest to prevent creases from
forming.)
1. Open door.
2. Before removing the laundry, remove fluff from the
micro-fine filter. It is best to use a damphand for this
purpose. (See "Cleaning and maintenance" chapter.)
3. Remove laundry.
4. Turn the programme selector to
5. Close the door.
After each use
• Clean the filters.
• Empty the water reservoir.
filters (fine filters and fluff filters) must be cleaned after
each drying cycle.
. Select the
ap-
off.