Download Print this page

Tecnico cb250 Manual page 161

Advertisement

Electric Starter/Starter Clutch
Troubleshooting
Starter Motor WiIl Not Turn
Check for a blownout main or sub fuses befo re servicing.
Makesure the battery is fully charged and in good condition.
Check for loose or poorly connected battery ter-
minals, and opened or shorted battery cable.
Abnormal
Poorly connected battery terminals
Openor short circuit in
batterv
cable
Normal
Abnormal
t-----------t~.
Poorly connected terrninals or 4P connector
Check for loose or poorly connected starter
relay switch terminals and 4P connector.
Normal
Check' for loose or poorly connected starter
motor cable, and open cable.
Abnormal
Poorlv connected motor cable
Open circuit in motor cable
Normal
L
Starter motor
does not turn
t
• Faulty starter motor
¡
Starter
motor
turns
Loase or disconnected starter motor cable
Faulty starter relay switch
Faulty neutral switch
Faulty neutral diode
Faulty c1utch switch
Faulty c1utch/side stand diode
Faulty side stand switch
Loose or poorcontactof connector
Open circuit wire harness
No continuity
Disconnect starter relay switch connector, and
check the relay coíl ground wire lines as below
for continuity:
1 . Green/Red
terrninal-clutch
switch
diode-
neutral switch line (with transrnission in
neutral and clutch lever released.)
2. Green/Red terrninal-clutch switch-side stand
switch line (in any gear except neutral and
with the c1utch lever pulled in and the side
stand up.)
Continuity
+
t
Clicks
With the ignition switch "ONu, push the starter
Connect the starter motor terminal to the bat-
switch and check for a "cllck " sound from the
tery positiveterminal directlv, (Because a large
starter relay switch.
amount of current flows, do not use thin wíres).
I
I
I
Connect the starter relay switch connector.
With the ignition switch ON and the starter
switch
pushed,
measure' the
starter
relay
voltage at the starter switch connector (be-
tween Yellow/Red
(+)
and ground
(-lL
I
Battery voltage comes
+
Check thestarter relay switch operation.
Novoltaqe
Normal
Faulty ignition switch
Faulty starter switch
Blown out main or sub fuses
Loose or poor contact of connector
Open circuit in wire
har~ess
Loose or poor contact of the starter relay
switchconnector
Abnormal
,-----"---' - -----' - ----
Faulty starter relay switch
15-3

Advertisement

loading