Download Print this page

Tecnico cb250 Manual page 159

Advertisement

15. Electric Starter/StarterClutch
Service Information
System Location
Troubleshooting
Starter Motor Removalllnstallation
Service Information
15-1
15-2
15-3
15-5
Starter Motor Disassembly/Assembly
Starter ClutchDisassembly/Assembly
Starter Driven Gear Removal/
Installation .
15-6
15-8
15-9
Always turn the ignition switch OFF befare servicing the starter motor. The motor could suddenly start, causing serious
injury .
A week battery may be unable to turn the starter motor quickly enouqh. or supply adequate ignition current.
Ifthe current is
kept
flowing through the starter motor to turn it while the engine is not cranking over. the starter motor
may be damaged.
For the following component inspections, refer to the following pages; for the parts locations, see page 15-2 or this
manual (System Location).
Clutch switch diode
Section 24 of the Common Service Manual
Starter motor
Section 24 of
the
Common Service Manual
Startérrelav switch
Section 24 of the Common Service Manual ("A" circuit type)
Clutch switch
Section 24 of the Common Service Manual
Neutral switch
Section 25 of the Common Service Manual
.,
Ignition switch
Checkfor continuity on the continuity chart of the Wiring Diagram. page 17-1.
Disconnect the switch connector inside the headlight case (page 1-19) and checkit.
Side stand switch
Section 25 of the Common Service Manual
15-1
\...
I
\...

Advertisement

loading