Changing The Battery - Ingenico iWL2 Series User Manual

4.5.4.
Changing the battery
It is imperative to use a battery authorized by Ingenico.
There is danger of explosion if battery used is not approved by Ingenico.
•
Remove the terminal from its base
•
Turn it off by pressing simultaneously
about one second
•
Remove the battery trapdoor (see section 4.5.2"installing battery")
•
Lift the battery and remove it from its compartment
•
Carefully disconnect battery, following the
instructions below.
a) Unlock the connector by pressing the locking
mechanism as indicated by F1 arrow while pulling
wires (F2 arrow ), to disconnect the connector.
Release traction on it as soon as the connector
comes unclipped
b) Finish extracting connector by tilting it slightly
(F3 arrow) to bring it away from the terminal
housing
•
Connect and install the new battery by following the instructions in section 4.5.2
"Installing battery"
•
Close the battery trapdoor and charge the new battery. See section "0 "Charging
the Battery"
•
In order to preserve the environnement, dispose used battery in compliance with
current country recycling legislation.
•
If the terminal is stored for a long time remove the battery from the terminal.
iWL2xx Wireless Series •
900003061 R11 000 04/1050
17/28
and (yellow key) for
Copyright © 2011 Ingenico
All rights reserved