Changing The Battery - Ingenico Link 2500 User Manual

It is imperative to use a battery authorized by Ingenico.
There is danger of explosion if battery used is not
approved by Ingenico.
Turn it off by pressing simultaneously
for about one second
Remove the battery trapdoor (see section 4.5.2"installing battery")
Lift the battery and remove it from its compartment
Carefully disconnect battery, following the
instructions below.
Extract the connector by pulling it slightly
(arrow) to bring it away from the terminal
housing.
Inform the terminal that battery
will be replaced (*). Do not start
the terminal or connecting terminal
power supply without battery.
Connect and install the new
battery by
instructions
"Installing battery"
Close the battery trapdoor and charge the new battery. See section
"Charging the Battery»
In order to preserve the environment, dispose used battery in
compliance with current country recycling legislation.
(*)The terminal memorizes that there is no battery simply by powering
up. It will then correctly perform-full recharge with the next battery.
The battery disconnection must be exceptional.
Battery connector durability: up to 30 mating cycles.
Link 2500 - Link 2500 I
900036315 R11 000 05/1022
4.5.4 Changing the battery (except Slim
and Integration version)
following
in section 4.5.2
and
the
Copyright© 2022 Ingenico -
Banks and Acquirers
17
International Holding SAS
All rights reserved
(yellow key)