Changing The Battery - Ingenico Link 2500 User Manual

4.5.4.
Changing the battery
It is imperative to use a battery authorized by Ingenico.
There is danger of explosion if battery used is not approved by Ingenico.
•
Turn it off by pressing simultaneously
one second
•
Remove the battery trapdoor (see section 4.5.2"installing battery")
•
Lift the battery and remove it from its compartment
•
Carefully disconnect battery, following the instructions below.
Connect, push
Disconnect, pull
•
Inform the terminal that battery will be replaced (*). Do not start the terminal or
connecting terminal power supply without battery.
•
Connect and install the new battery by following the instructions in section 4.5.2
"Installing battery"
•
Close the battery trapdoor and charge the new battery. See section "4.5.3
"Charging the Battery"
•
In order to preserve the environment, dispose used battery in compliance with
current country recycling legislation.
(*)The terminal memorizes that there is no battery simply by powering up. It will then
correctly perform‐full recharge with the next battery.
USER GUIDE •
R11 900019007 000 02
and
18/24
(yellow key) for about
Copyright © 2012 Ingenico
All rights reserved