Base Downside Connections - Ingenico iWL2 Series User Manual

5.1.2.
Base downside connections
•
Remove base trapdoor pushing on clips
( see clips location at red arrows)
•
Connect all downside connections
•
Use "path for wires" to
manage cable exit
•
Close trapdoor
G= Serial link COMØ – RS232 (optional)
I = Modem socket (optional)
Follow the below instructions to connect the base to the telephone network :
•
Disconnect power supply unit (socket B) in order to switch off the base prior to
connecting it to the appropriate network.
•
Connect telephone cable equipped if necessary with user country specific
telephone plug, to the telephone network.
•
Connect the other end of the wire to the base (socket I).
•
Connect the mains power supply wire to the base (socket B).
•
Connect base power supply block to the mains .
Socket I : TNV‐3 circuit: Telecommunication Network Voltage, as per safety standard EN
60950‐1.
iWL2xx Wireless Series •
900003061 R11 000 04/1050
19/28
G
H
I
H= Serial link COM1 – RS232 (optional)
Copyright © 2011 Ingenico
All rights reserved
Path for wires
B