Table of Contents
Advertisement
If the R
PM readings are working correctly and the engine throttle settings are correct, the tachom
operatin
g properly. If the tachometer is not reading correctly, refer to the manual provided
manufa
cturer of the gauge that was included in your owner's package.
S
peedometer
The speedom
eter (speedo) is located on the console. To ensure that the speedo is working properly, get
the boat on a planing speed and check to see if it is reading at the approximate running speed at which
the boat is traveling.
Note: The speed-re
the boat is traveling. Either a GPS or a radar gun can check the running speed.
Trim
To ensure the trim gauges/indicators are working properly, start by making sure the engine is trimmed all
the way down.
Locate the trim gauge on the instrument panel and check to see if the level on the trim
gauge is in the full down position. As you trim the engine up, watch the trim gauge and ensure that it
coincides with the actual trim of the engine. When finished trimming the engine all the way up, the level
on the trim gauge sho
uld read in the full up position.
Volts
To syst
em check the volt gauge, turn the ignition key on and turn on the engine. With the engine ru
check t
he reading on the volt gauge. It should be reading between 12 and 14.5 volt
e
nsures that the charging system and the volt gauge are working properly.
Fuel
The fuel gauge reads the amount of fuel remaining in the tank. To check the fuel gauge, place a known
amount of fuel into the fuel fill and fill the tank. Turn the ignition key on and the fuel gauge should read
the approximate amount of fuel in the tank.
For example: If the fuel tank holds 140 gallons of fuel and you pumped 35 gallons of fuel
into the tank, the fuel gauge should read approximately ¼ of a tank. This ensures that
the fuel tank gauge and the fuel sender are working properly.
If the fuel gauge is not reading correctly, we recommend that you have the
P
ro-Line dealer's Service Department or a qualified service professional before considering changing out
the ga
uge. For more information, please refer to the Fuel/Oil Systems section of this manual.
For specific information related to your gauges, refer to the materials in your owner's package that was
provided by the gauge manufacturer.
Fresh
/ Cabin Water System
Note: There must be fresh water in the fresh water tank in order for the fresh water pump
to operate. Operating the fresh water pump with an empty tank could cause serious
damage to the fresh water pump.
Fresh Water Tank
The 6-gallon capacity fresh water tank can be filled via the stainless steel fresh water tank fill, labeled
w
ater, located next to the port side helm
lo
cated at the port helm seat. See the Fresh Water Tank Fill and/or the City Water Hook-Up/Inlet sections
below for filling procedures.
ading on the speedo may vary a few mph from the actual speed that
seat. The tank can be reached by removing the tackle box
eter is
by the
nning,
s. This reading
fuel sender checked by your
22
Advertisement
Table of Contents
