Installation - Danfoss CF-RC Instruction

Instruction CF-RC Remote Controller

2. Installation

Note:
• Install the Remote Controller after you have installed all the Room Thermostats, see fig. 5-b
• Remove the strip to connect the enclosed batteries
• Carry out the assignment of the Remote Controller to the Master Controller within a
distance of 1½m
• When the back light in the display is out, the first touch of a button only activates this light
Activate Install mode on the Master Controller - fig. 3
• Use the menu selection button
The install LED flashes
• Activate Install mode by pressing OK
Activate Install mode on the Remote Controller - fig. 1
• When the batteries have been connected, follow the installation guide,
beginning with the selection of language
• After the installation process, set time and date. Use the up/down selector
and the left/right selector
OK activated by soft key  ( )
• The installation process is concluded with the opportunity to name the
rooms in which the Room Thermostats are placed. This makes access to and
handling of the system very easy
• In the Name rooms menu, activate the change menu with soft key 2 ( ) to
change the default room names from e.g. MC Output .2 (Master Controller
, output  and 2) to living room, and confirm with OK. You can also use the
spell.... menu to create other names
• When the installation is finished the start up screen will be shown in the
display with the actual time and date on the top. The screen also shows the
actual temperature in the room from the top of the rooms list.
See chapter 5.3 to select another room for the start up screen
Note: Keeping a button activated during settings will make the value change faster
VI.UH.M4.1C
to select the Install mode.
. The install LED
to carry out the settings. Confirm settings with
Produced by Danfoss Floor Heating Hydronics 03.2007
goes ON
GB
5