Menus - Danfoss CF-RC Instruction

Instruction CF-RC Remote Controller
• Before you place the back plate/docking station on the wall, verify the trans-
mission to the Master Controller from the desired location by carrying out a
link test (see chapter 3)
• Mount the back plate/docking station on the wall with the screws and wall
plugs
• Connect the docking station to a 230V power supply outlet by means of the
transformer/power supply plug
• Place the Remote Controller in the docking station
Note: To extend the transmission range of the CF2 system, up to three Repeater Units can be
installed in a chain – see fig. 4

5. Menus

Note: When the back light in the display is out, the first touch of a button only activates this light.
5.1 Rooms
From the start-up screen, activate the:
Rooms menu to access a list of all the rooms in the system. Select the desired
room with OK to enter the screen for that room. Here you can see information
about the set and actual temperatures:
: Indicates that this room is included in an ongoing time
program (see chapter 5.2)
: Indicates that the Room Thermostat is running low on battery
: Indicates that the value set on the Room Thermostat is beyond the
max./min. limitations set by the Remote Controller
: Indicates that the set temperature is above the actual temperature
: Indicates that the set temperature is below the actual temperature
VI.UH.M4.1C
Menu
Rooms
Produced by Danfoss Floor Heating Hydronics 03.2007
GB
7