Transmission Test - Danfoss CF-RC Instruction

Instruction CF-RC Remote Controller
3. Transmission Test
Initiate a transmission test on the Remote Controller
From the start-up screen, activate the:
Menu
Setup
Link test
Link test menu to activate a test of the wireless transmission between the
Master Controller and the Remote Controller. The status of the link test will be
displayed right after the test has been carried through.
If the link test is not successful:
• Try to relocate the Remote Controller in the room
• Or install a Repeater Unit (CF-RU, see fig. 5 c), and place it between the Master
Controller and the Remote Controller
Note: The link test may take a few minutes depending on the size of the system
4. Mounting
The Remote Controller has been installed – fig. 2
When the Remote Controller has been installed to the
Master Controller (see chapter 2), it can be mounted on the wall by means of
the back plate/docking station . This makes it possible to connect the Re-
mote Controller to a 230V power supply with the included transformer/power
supply plug . When it is not in the docking station, the Remote Controller is
powered by two AA Alkaline .5V batteries.
VI.UH.M4.1C Produced by Danfoss Floor Heating Hydronics 03.2007