Change The Print And Retransfer Ribbons; Change The Print Ribbon; Remove The Print Ribbon - Rimage Professional 3400 User Manual

Change the Print and Retransfer Ribbons

This section provides the information needed to change the print and retransfer ribbons in the integrated Everest 400
printer. Change a 3-color (CMY) print ribbon after 500 discs, a back (monochrome) print ribbon after 1000 discs, and the
retransfer ribbon after 500 discs.

Change the Print Ribbon

Before you change or first install a new Everest print ribbon, allow time for the new ribbon to become acclimated to the
environment. Allow more time for greater temperature and humidity differences.
-
Important!
• Rimage supports only the use of Rimage brand ribbons in our printers. Printer issues that occur as a result of using
ribbons from manufacturers other than Rimage are not included under your Rimage warranty or maintenance
agreement.
• For optimum results, make sure that Everest ribbons are stored at a temperature between 41° and 95°F (5° to 35°C)
and humidity level between 45% and 85%.
• Avoid moisture and direct sunlight.
• Do not reuse ribbons.
• Use only ribbons designed for your model of Everest 400 printer.
• The ribbon carriers cannot be removed from the printer unless the system is powered on.

Remove the Print Ribbon

1. Open the side cover on the left side of the autoloader.
a. Lift the printer cover latch to open the printer cover.
b. Lower the printer cover.
2. Access the print ribbon.
a. Turn the center latch
counterclockwise to unlock it.
b. Pull the print ribbon carrier all the
way out of the printer.
-
Important! The ribbon carriers
cannot be removed from the
printer unless the system is
powered on.
2001431_B
Printer
Cover
Print Ribbon
Carrier
Printer Cover Latch
Left Side of Autoloader
Center Latch
27