Table of Contents
Advertisement
Appendix B
Rear Signal Connector Signal Descriptions, Serial Configuration
Pin
Signal Name
24 or 50
DIG GND
25
SERDATIN
26 or 47
SERDATOUT
27
DAQD*/A
29
SLOT0SEL*
31 or 37
SERCLK
* Indicates active low.
All other pins are not connected.
See the
Timing Requirements and Communication Protocol
and
Installation, for more detailed information on timing.
Rear Signal Connector Signal Descriptions, Parallel Configuration
Pin
Signal Name
47, 45, 43,
In <0..31>
41, 39, 37,
35, 33, 31,
29, 27, 25,
23, 21, 19,
17, 15, 13,
11, 9, 7, 5, 3,
1, 48, 46, 44,
42, 40, 38,
36, 34
50
GND
© National Instruments Corporation
Description
Digital Ground – Supplies the reference for data
acquisition board digital signals and is tied to the
module digital ground. Pin 50 is for DIO-type
boards. Pin 24 is for MIO-type boards. Jumper W3
selects the pin.
Serial Data In – Taps into the SCXIbus MOSI line
to provide serial input data to a module or Slot 0.
Serial Data Out – Taps into the SCXIbus MISO line
to accept serial output data from a module. Pin 47
is for DIO-type boards. Pin 26 is for MIO-type
boards. Jumper W5 selects the pin.
Data Acquisition Board Data/Address Line – Taps
into the SCXIbus D*/A line to indicate to the
module whether the incoming serial stream is data
or address information.
Slot 0 Select – Taps into the SCXIbus INTR* line
to indicate whether the information on MOSI is
sent to a module or to Slot 0.
Serial Clock – Taps into the SCXIbus SPICLK line
to clock the data on the MOSI and MISO lines. Pin
31 is for DIO-type boards. Pin 37 is for MIO-type
boards. Jumper W2 selects the pin.
section in Chapter 2,
Description
Digital Inputs – The logic levels at these inputs
determine the output states.
Ground – Supplies ground reference for the
parallel inputs.
B-3
Rear Signal Connector
Configuration
SCXI-1163 User Manual
Advertisement
Table of Contents
