Index - National Instruments SCXI-1163 User Manual

Index

Numbers
+5 V signal, 3-3, C-3
A
Address Handler
description, 4-2
register addresses, 4-2
selecting Data Register, 3-6
timing diagram, 2-21
writing to Address Handler, 2-21, 5-3
analog backplane protection, 3-7
AT-MIO board connection. See DIO-96,
AT-MIO-16D, and AT-MIO-64F-5
board connection.
B
backplane protection, 3-7
C
cabling
custom cables, optional, 1-3 to 1-4
DIO-96, AT-MIO-16D, and
AT-MIO-64F-5 board connection
SCXI-1163 and board pinout
equivalences, E-8 to E-9
SCXI-1351 and NB5 cable
assembly, E-7
SCXI-1351 and NB5 installation,
E-9 to E-10
multiple-chassis connections,
E-16 to E-17
SCXI-1180 feedthrough panel
cable assembly, E-12
installation, E-12 to E-13
SCXI-1302 50-pin terminal block
cover removal, E-15
installation, E-15
wiring procedure, E-14
SCXI-1340 cable assembly, E-1 to E-2
installation, E-3
SCXI-1163 and board pinout
equivalences, E-2
© National Instruments Corporation
SCXI-1341 Lab-NB, Lab-PC, or
Lab-PC+ cable assembly, E-4
installation, E-5
pin translations, E-4
SCXI-1342 PC-LPM-16 cable
assembly, E-5
installation, E-6
pin translations, E-6
SCXI-1343 rear screw terminal adapter
cable assembly, E-17
installation, E-18
pin connections, E-17 to E-18
SCXI-1344 Lab-LC cable assembly, E-4
installation, E-5
pin translations, E-4
SCXI-1348 DIO-32F cable
assembly, E-10
installation, E-12
pin translations, E-11
SCXI-1350 multichassis adapter,
E-16 to E-17
SCXI-1351 one-slot cable extender
cable assembly, E-15
installation, E-16
channels. See output channels.
CHS<4..0> bit, Slot-Select Register, 4-8
CHSGND signal, SCXIbus connector,
3-3, C-3
communication signals, 2-19 to 2-24
Address Handler timing diagram, 2-21
communicating on SPI bus, 2-19
Data Register write timing diagram, 2-22
Module ID Register timing
diagram, 2-23
reading from Module ID Register, 2-23
reading from Status Register, 2-24
selecting a slot, 2-19
serial data timing diagram, 2-20
slot-select timing diagram, 2-19
SPI protocol, 2-3
Status Register timing diagram, 2-24
writing the slot-select number, 2-20
writing to Address Handler, 2-21
configuration. See jumper configuration;
module configuration;
signal connections.
custom cables, optional, 1-3 to 1-4
customer communication, xii, F-1
Index-1 SCXI-1163 User Manual