Table of Contents
Advertisement
SCXI-1163 Cabling
SCXI-1341 Lab-NB, Lab-PC, or Lab-PC+ and SCXI-1344
Lab-LC Cable Assembly
The SCXI-1341 Lab-NB, Lab-PC, or Lab-PC+ cable assembly connects a Lab-NB, Lab-PC, or
Lab-PC+ board to an SCXI-1163 module. The SCXI-1344 Lab-LC cable assembly connects a
Lab-LC board to an SCXI-1163 module. The SCXI-1341 and SCXI-1344 cable assemblies
consist of two pieces–an adapter board and a 50-conductor ribbon cable that connects the Lab
board to the rear connector of the adapter board. The adapter board converts the signals from the
Lab board I/O connector to a format compatible with the SCXI-1163 rear signal connector pinout
at the front connector of the SCXI-1341 or SCXI-1344. The adapter board also has an additional
male breakout connector that provides the unmodified Lab board signals for use with an
SCXI-1180 feedthrough panel or SCXI-1181 breadboard module. The adapter board gives the
Lab boards full access to the digital control lines. The position of jumper W1 on the SCXI-1341
and SCXI-1344 is irrelevant because the SCXI-1163 does not use jumper W1. Table E-2 lists the
SCXI-1341 and SCXI-1344 pin translations.
Table E-2. SCXI-1341 and SCXI-1344 Pin Translations
Lab Board Pin
1
2
3
4
5
6
7
8
9
10
11
12
13, 50
26
27
28
29
31
32
40
43
49
All other pins of the Lab board pinout are not sent to the SCXI-1163 rear signal connector.
SCXI-1163 User Manual
Lab Board Signal
ACH0
ACH1
ACH2
ACH3
ACH4
ACH5
ACH6
ACH7
AIGND
DAC0OUT
AOGND
DAC1OUT
DGND
PB4
PB5
PB6
PB7
PC1
PC2
EXTCONV*
OUTB1
+5 V
E-4
SCXI-1163 Pin
3
5
7
9
11
13
15
17
1-2
20
23
21
24
25
27
29
37
26
28
36
46
34-35
© National Instruments Corporation
Appendix E
SCXI-1163 Signal
No Connect
No Connect
No Connect
No Connect
No Connect
No Connect
No Connect
No Connect
No Connect
No Connect
No Connect
No Connect
DIG GND
SERDATIN
DAQD*/A
SLOT0SEL*
SERCLK
SERDATOUT
No Connect
No Connect
No Connect
No Connect
Advertisement
Table of Contents
