Download Print this page
National Instruments SCXI-1320 Instructions For Safe Use
National Instruments SCXI-1320 Instructions For Safe Use

National Instruments SCXI-1320 Instructions For Safe Use

Hide thumbs Also See for SCXI-1320:

Advertisement

Quick Links

I
NSTRUCTIONS FOR
SCXI H
ARDWARE
Introduction
The Software is the Instrument
trade names of their respective companies.
321402A-01
S
This document describes overvoltage protection limits for the following
National Instruments SCXI products. The information in this document
supersedes any other voltage protection limits in your other National
Instruments documentation:
SCXI-1320
SCXI-1321
SCXI-1322
SCXI-1324
SCXI-1325
SCXI-1326
SCXI-1327
SCXI-1328
SCXI-1120
SCXI-1121
SCXI-1122
SCXI-1124
SCXI-1160
SCXI-1161
SCXI-1162
SCXI-1162HV
SCXI-1163
SCXI-1163R
®
and SCXI
are trademarks of National Instruments Corporation. Product and company names are trademarks or
© Copyright 1996 National Instruments Corp. All rights reserved.
U
AFE
SE OF
Y
OUR
TBX-1325
TBX-1326
TBX-1328
November 1996

Advertisement

loading
Need help?

Need help?

Do you have a question about the SCXI-1320 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for National Instruments SCXI-1320

  • Page 1 ® ™ The Software is the Instrument and SCXI are trademarks of National Instruments Corporation. Product and company names are trademarks or trade names of their respective companies. 321402A-01 © Copyright 1996 National Instruments Corp. All rights reserved. November 1996...
  • Page 2 If the device is damaged, turn the device off and do not use until service-trained personnel can check its safety. If necessary, return the device to National Instruments for service and repair to ensure that its safety is not compromised.
  • Page 3 To connect the safety earth ground to the safety ground solder lug, run an earth ground wire in the cable from the signal source to the terminal block. National Instruments is liable for any damages or injuries resulting from inadequate safety earth ground connections.
  • Page 4 Relieve strain on your signal wires by tie-wrapping them to the mounting rails of your rack. National Instruments Customer Support If you have additional questions, please contact our technical support staff at: Tel: (512) 795-8248, Fax: (512) 794-5678. Our corporate headquarters address is: 6504 Bridge Point Parkway, Austin, TX 78730-5039, Tel: (512) 794-0100.