Sub-Zero ICB648PRO Installation Instructions Manual page 15

P R O 4 8 I N S TA L L AT I O N I N S T R U C T I O N S
M O V I N G T H E P R O 4 8
fter you've completed the steps for unpack-
ing the PRO 48 and have removed the grille
and installed the anti-tip bracket, carefully
move the unit onto an appliance dolly. When
securing the unit on the appliance dolly, use
the corner protectors retained from the pack-
aging under the strapping to avoid damage to
the stainless steel exterior. lso, secure the
doors and drawers closed with the strapping.
Refer to the illustration below for proper
placement of the appliance dolly.
IMPORT NT NOTE: Protect the surrounding
finished flooring with masonite, plywood,
3 mm pressed fiberboard or other suitable
material before moving the unit across it.
Carefully move the PRO 48 into place near the
rough opening and move it off of the appliance
dolly. The PRO 48 is equipped with rollers, so it
can be moved into position more easily.
The PRO 48 is very heavy – 401 kg or
408 kg – be sure to have adequate
manpower when moving and positioning
the unit. Secure doors and drawers
closed before moving the unit.
Proper placement of appliance dolly
Retract the front leveling legs all the way up to
allow the unit to be moved into position more
easily. You will extend the front leveling legs
down and adjust once the unit is in position.
IMPORT NT NOTE: The rear levelers must be
in their lowest position in order to push the
unit back into the rough opening. Therefore,
leveling cannot be completed until the unit is
in position.
Shut off power to the wall outlet. Plug the
power supply cord into the 10 amp grounded
outlet and roll the unit into position. Be sure
that the anti-tip bracket is properly engaged.
IMPORT NT NOTE: If for any reason the unit
has been laid on its back or side, you must
allow the unit to stand upright for a minimum
of 24 hours before connecting power.
15