Pro 48 Installation Instructions; Electrical Shock - Sub-Zero ICB648PRO Installation Instructions Manual

P R O 4 8
E L E C T R I C A L
ance, is required. The electrical supply should
be located within the shaded area shown in
the illustration below.
The unit is equipped with a detachable power
supply cord with a grounded (earthed) plug
which must be plugged into a mating
grounded (earthed) wall receptacle. Follow
local codes and ordinances when installing the
receptacle.
IMPORT NT NOTE:
interrupter (GFCI) is not recommended and
may cause interruption of operation.
IMPORT NT NOTE: The unit is equipped with
an appliance inlet type device. This allows
easy replacement of the power cord. The appli-
ance inlet is located on top of the unit on the
compressor shroud.
Electrical Requirements
Power Supply
Circuit Breaker
Receptacle
Location of electrical supply.
10
I N S TA L L AT I O N I N S T R U C T I O N S
R E Q U I R E M E N T S
separate circuit, servicing only this appli-
ground fault circuit
220-240 V C, 50/60 Hz
grounding-type (earthed)
FRONT VIEW
178
E
mm
152
mm
1918 mm
FROM
FLOOR
Electrical ground (earthing) is required on
this appliance. Do not defeat the ground-
ing (earthing) nature of the power cord.
The outlet must be checked by a qualified
electrician to be sure that it is wired
correctly. Verify that the outlet provides
the proper voltage and is properly
grounded (earthed).
lways shut power off at the circuit
breaker before performing any installa-
tion, service or maintenance.
10 amp
Plug power cord directly into a properly
grounded (earthed) outlet.
Do not defeat the grounding (earthing)
nature of the plug.
Do not use adapter or extension cord.
Failure to follow these instructions could
cause serious injury or death.
See installation instructions
Electrical
Shock
Hazard