Table of Contents
Advertisement
• Active termination ensures error-free data transfer
• Connector type:
- External: One high-density 50-pin
System Requirements
For PCs:
• Pentium-Class computers with one available PCI slot
• Windows 3.1x/95/98/98SE/2000/NT4.0
For MACs:
• Power Mac
slot
• MAC OS 8.1 or higher
Software Installation
The following sections describe the procedures for installing drivers
to enable your Fast SCSI Pro to operate properly under specific
operating system environments.
The Fast SCSI Pro is designed for adding only external SCSI devices
to your system. It does not include an on-board BIOS to support the
boot-up function; therefore, it must coexist with an IDE or other
hard disk controller. Drivers support for DOS, Windows 3.1x,
Windows 95, Windows 98/98SE, Windows 2000, Windows NT4.0,
and MAC OS are provided.
Driver Installation for PC Systems
It is important that the SCSI bus hardware and
operating system are installed correctly before
proceeding further.
DOS/Windows 3.1 Driver Installation
Perform the following steps to install the driver for the MS-DOS/
Windows 3.1x operating system:
1. Insert the Driver & Utility CD into your CD-ROM Drive.
(Assuming D: is your CD-ROM drive).
2
G3 or Mac ® computer with one available PCI
TM
IMPORTANT
Advertisement
Table of Contents
