Table of Contents
Advertisement
5.
Connect the system's power connector to the drive's
power connector.
6.
Replace the PC's cover after all the connections have
been made and plug-in the power cord.
Software Installation
This section provides information on how to install the
SerialATA+Ultra ATA Combo drivers.
Windows 98/98SE Driver Installation
For New Windows 98/98SE Installation
1.
Follow Microsoft procedures to install Windows 98
accordingly.
2.
Once Windows has been installed, right click My
Computer and click Properties. Select Device
Manager tab.
3.
Double click PCI Mass Storage Controller listed
under Other Devices.
4.
Select Driver tab, then click Update Driver button.
5.
Insert the driver diskette and click Next.
6.
Select Search for a better driver... and click Next.
7.
Check Floppy disk drives, clear the other boxes,
then click Next. Click Next again, then Finish.
8.
Remove the driver diskette and restart Windows to
complete driver installation.
For Existing Windows 98/98SE Installation
1.
Boot up Windows.
2.
At the Add New Hardware Wizard, click Next.
3.
Select Search for the best driver for your device and
click Next.
5
Advertisement
Table of Contents
