B Power Supply Synchronization Setting (L - L) - Sanyo VCC-6975 Instruction Manual

USING THE MENU SCREEN
B Power supply synchronization setting (L - L)
When using a camera switcher to connect 2 cameras or more to one monitor, there may be a
vertical roll of the images when switched. In such a case, set as described below.
1
Press the CURSOR (l, then d or c) button to change the SYNC setting to "L - L"
(the setting will flash), then press the SET button.
The ADJUSTMENT FOR L - L screen will be displayed.
2
Switch the display on the monitor from camera 1 to camera 2.
Press the CURSOR (d or c) button to adjust the vertical sync phase.
Returning the value to the default setting
Press the CURSOR (l, then d or c) button to change the PRESET setting to ON, then
press the SET button.
CURSOR
SET
PRESET
3
When finished:
Press the CURSOR (l) button to select BACK (it will flash) at the bottom of the screen.
Then press the CURSOR (d or c) button to change BACK to END, and press the SET
button.
To return to the previous screen, select BACK then press the SET button.
Note: Power supply synchronization setting is not possible when a 12 V DC power supply is
being used.
ON
OFF
MAIN MENU
CURSOR
SET
LANGUAGE
CAMERA ID
SYNC
ADJUSTMENT FOR L-L
[V SYNC PHASE]
í--ú---z------ü 110
CURSOR
CURSOR
SET
MENU
MENU
SYNC/L-L
SET p
OFF
L-L p
BACK
END
18
English