Using The Menu Screen - Sanyo VCC-6975 Instruction Manual

USING THE MENU SCREEN

This unit is set at the factory so that it can be used with a DC type auto-iris lens (sold separately).
Therefore, under normal conditions, additional settings or adjustments are not necessary.
Depending on the conditions of use, if settings or adjustments are required they can be done
from the "MAIN MENU" setting screen.
1
Press the SET button for about 3 seconds.
The MAIN MENU screen will be displayed.
2
Using the CURSOR button
1
Press the CURSOR (l) button to move the cursor down. When the cursor reaches the
bottom of the screen, it goes back up to the top of the screen.
2
Press the CURSOR (j) button to move the cursor up. When the cursor reaches the top
of the screen, it goes back down to the bottom of the screen.
3
Press the CURSOR (c) button to move the cursor to the right. This button is also used
to change ON/OFF settings etc.
4
Press the CURSOR (d) button to move the cursor to the left. This button is also used to
change ON/OFF settings etc.
Switching to sub-menu screens
Press the CURSOR (j, l, d or c) button until an item with a "c" next to it is flashing,
then press the SET button.
Switching to the MAIN MENU screen
Press the CURSOR (j or l) button to select BACK (it will flash), then press the SET button.
3
When finished:
Press the CURSOR (l) button to select END (it will flash), then press the SET button. The
display will return to the normal monitor screen.
(Default setting)
SET
MAIN MENU
LANGUAGE
CAMERA ID
SYNC
IRIS
WHITE BALANCE
2
SHUTTER
MOTION
CURSOR
OPTION
4 3
MENU
1
(Example)
CURSOR
SET LANGUAGE
LANGUAGE
LANGUE
SPRACHE
CURSOR
SET
MENU
CURSOR
SET
MENU
SET p
OFF
INT
AI p
ATW p
OFF
OFF
SET p
END
ENGLISH
FRENCH
GERMANY
BACK
END
12
English