Sanyo VCC-6975 Instruction Manual page 5

PARTS NAMES
8
9
F
G
A
8
Camera setup section (under the cover)
To access the controls, loosen the cover fixing screw A, then remove the cover.
a b
a
Address setting switch (RS485 ADDRESS) . . . See page 56
b
Terminater switch (TERMINATE) . . . . . . . . . . See page 56
c
Auto iris lens switch (A. I. LENS) . . . . . . . . . . See page 6
9
Lens iris output connector (LENS)
This 4-pin connector is used to send the DC control signal and power supply to an auto-iris type lens.
F
Menu setting button (SET)
Connect the camera to the monitor, then press the SET button for about 3 seconds to display the on-screen
menu.
G
Cursor button (CURSOR)
j: Press this button to move the cursor up.
c: Press this button to move the cursor to the right, or to turn the settings ON/OFF etc.
d: Press this button to move the cursor to the left, or to turn the settings ON/OFF etc.
l: Press this button to move the cursor down.
c
4
English