Table of Contents
Advertisement
USING THE MENU SCREEN
C
MASKING setting
1
Press the CURSOR (l, then d or c) button to set MASKING to "ON" (the setting
will flash), then press the SET button.
The MOTION MASKING screen will be displayed, and the mask cursor will flash in the
top-left corner of the screen.
2
Press the CURSOR (d, c, j or l) button to move the mask cursor to the place
where movement is not to be detected, then press the SET button.
The position of the mask cursor will be fixed, and the area will increase each time the
CURSOR button is pressed. Press the CURSOR button repeatedly to set the masking area.
Masks can be applied to a maximum of 64 separate sections (8 x 8).
Note: If you apply a mask to a wrong area by mistake, press the SET button once more to
clear the mask.
3
When the mask has been applied, press the CURSOR (l) button to move the mask
cursor to the bottom edge of the screen, and continue pressing the CURSOR button
for about 3 seconds.
Returning to the default setting
Press the CURSOR (l, then d or c) button to change the PRESET setting to ON, then
press the SET button.
MOTION/MASKING
CURSOR
ADJUSTMENT FOR MOTION
SET
DIRECTION
SIZE
MASKING
MOTION MASKING
CURSOR
SET
CONT PRESS(ñ)
(Example)
OFF
SET
p
ON
p
40
English
Advertisement
Table of Contents
