Dsensitivity Setting - Sanyo VCC-6975 Instruction Manual

USING THE MENU SCREEN
D SENSITIVITY setting
The smaller the setting value, the greater the sensitivity.
Press the CURSOR (l) button to select the SENSITIVITY setting "SET" (the setting will flash),
then press the SET button.
The SENSITIVITY screen will be displayed.
MOVE
This sets the movement amplitude of subjects on the screen.
Press the CURSOR (d or c) button so that the MOVE value is flashing. (Maximum: 6)
Set the value to a large to avoid detecting slight movement such as movement caused by the wind.
Y-LEVEL
This sets the brightness level. Any signal darker that the set brightness will be ignored.
This is mainly used to avoid incorrect detection caused by electronic noise in a dark
picture.
Press the CURSOR (l, then d or c) button so that the Y-LEVEL value is flashing. (Maximum: 10)
Set the value to a large to avoid incorrect detection of movement caused by electronic noise
from a dark picture.
Y-DIFFER
This sets the brightness change level. A lower setting will ignore bigger changes in the
brightness.
Press the CURSOR (l, then d or c) button so that the Y-DIFFER value is flashing.
(Maximum: 10)
This allows movement to be detected when there are variations in brightness. Set the value to a
large if lights being turned on and off are not to be detected.
MOTION/SENSITIVITY
CURSOR
ADJUSTMENT FOR MOTION
SET
DIRECTION
SIZE
MASKING
SENSITIVITY
SENSITIVITY
CURSOR
SET
MOVE í---ú----ü
Y-LEVEL í-ú------ü
Y-DIFFER í------ú-ü
DURATION ú--------ü
OFF
SET p
ON p
SET p
3
3
8
1
42
English