Finterval Setting; Galarm Sign Setting - Sanyo VCC-6975 Instruction Manual

USING THE MENU SCREEN
F INTERVAL setting
Press the CURSOR (l) button so that the INTERVAL value is flashing, then press the CURSOR
(d or c) button repeatedly.
After an alarm signal has been output once, this sets the length of time that no further alarm
signal is output when movement is detected.
G ALARM SIGN setting
Press the CURSOR (l, then d or c) button to change the ALARM SIGN setting to "ON" or
"OFF".
OFF: No alarm display appears
ON: The camera ID flashes when movement is detected.
Note: If the camera ID display is not turned on, the camera ID which has been set in the
CAMERA ID SETTING screen will flash. The length of time that the camera ID flashes is
the same as the length of time for the alarm ignore time (INTERVAL) setting.
When finished
Press the CURSOR (l) button to select BACK (it will flash) at the bottom of the screen. Then
press the CURSOR (d or c) button to change BACK to END, and press the SET button.
To return to the previous screen, select BACK then press the SET button.
Returning to the default setting
Press the CURSOR (l, then d or c) button to change the PRESET setting to ON, then press
the SET button.
MOTION/INTERVAL, ALARM SIGN
ADJUSTMENT FOR MOTION
DIRECTION
SIZE
MASKING
SENSITIVITY
CURSOR
ZOOM
INTERVAL
5S 10S 15S 20S 30S
5M 4M 3M
ADJUSTMENT FOR MOTION
DIRECTION
SIZE
MASKING
SENSITIVITY
CURSOR ZOOM
INTERVAL
ALARM SIGN
????????
CURSOR
SET
MENU
MENU
OFF
SET p
OFF
SET p
OFF p
5S
2M 1M
OFF
SET p
OFF
SET p
OFF p
5S
ON
BACK
END
44
English