Table of Contents
Advertisement
USING THE MENU SCREEN
C
External sync setting (VBS)
1
Connect the output signal from the other camera to the external sync input
connector of this camera.
The SYNC setting in the MAIN MENU screen will change to VBS.
2
Press the CURSOR (l) button to select the SYNC setting "VBS" (the setting will
flash), then press the SET button.
The ADJUSTMENT FOR VBS screen will be displayed.
3
The H (horizontal) value will flash. Press the CURSOR (d or c) button to adjust the
horizontal sync phase.
Note: If not using a camera (for the output signal), use a sync signal generator.
4
Press the CURSOR (l) button until the SC1 (sub-carrier) value is flashing, then press
the SET button to select the color phase (SC1 to SC4).
5
Press the CURSOR (d or c) button to make fine adjustments to the color phase.
Returning the value to the default setting
Press the CURSOR (l, then d or c) button to change the PRESET setting to ON, then
press the SET button.
19
English
MAIN MENU
LANGUAGE
CAMERA ID
SYNC
CURSOR
SET
ADJUSTMENT FOR VBS
[PHASE]
H íú-----z------ü
SC1 ú------z------ü
SC1
SC2
SC3
SYNC/VBS
SET
p
OFF
VBS
p
30
1
SC4
Advertisement
Table of Contents
