HP P2000 G3 MSA Reference Manual page 52

431
Error Replication to the indicated secondary volume has suspended due to an error on that volume. User
intervention is required to resume replication. This can occur for several reasons, such as:
• The cache request was aborted.
• The cache detected that the source or target volume is offline.
• The cache detected a media error.
• The snap pool is full.
• The communication link is busy or experienced an error.
• The snapshot being used for the replication is invalid.
• There was a problem establishing proxy communication.
Recommended actions
• Resolve the error and then resume the replication.
432
Error Aborted a replication due to an error on the indicated secondary volume.
Recommended actions
• Verify that the secondary volume is valid and that the system where the volume resides is accessible.
433
Info. Skipped a replication to the indicated secondary volume.
Recommended actions
• No action is required.
434
Warning A replication collided with an ongoing replication to the indicated secondary volume.
A replication was in progress for the replication set when a new replication was requested. The new
replication has been queued.
Recommended actions
• This can be a normal operation, but in some cases this can indicate a problem. Ensure that: there are
no network issues; there is sufficient bandwidth between the primary and secondary systems; the
interval between replications is set to a sufficient amount of time to allow replications to complete.
Having too many replications queued can result in some replications not completing.
435
Warning Failed to initialize the indicated replication set.
This can occur because:
• Firmware in the remote system is incompatible with firmware in the local system.
• The primary volume and secondary volume involved in replication cannot communicate.
Recommended actions
• Update the firmware on one or both systems so they are running the same version.
• Check your network or fabric for abnormally high congestion or connectivity issues.
436
Warning Firmware in the remote system is incompatible with firmware in the local system so they cannot
communicate with each other to perform replication operations.
Recommended actions
• Update the firmware on one or both systems so they are running the same version.
52 Event descriptions